Thought I would go ahead and write a review/install walkthrough since no one wrote one on here! Take about an hour if you don’t care for cable management.
Setup fans, follow instructions and label each fan, they must be plugged into the commander pro IN ORDER. If you don’t then all the fans will malfunction. You need to plug the commander pro into your power supply with the computer completely off via SATA, then plug the USB 2.0 into the MB. Don’t plug the commander pro into a dedicated fan pin on the MB because the commander pro will not work.
After setting up your CORSAIR RGB fans into the “lighting node pro” that comes with the 3 pack (in order). This must also be plugged into the power supply via SATA. Then plug the Power cords into the command pro ports labeled “fan” (in order). Instead of using the lighting controller, use a 3 pin female adapter to connect the lighting node pro into the commander pro port labeled “LED 1”. Make sure to do this same technique if adding more than 3 fans, and keep the fans plugged into the commander pro in order. I’m attaching a diagram I found on corsairs website. Hopefully this helps!
The commander pro is an amazing product! I is an essential to anyone who wants to control their fan speed and colors with iCue. I did previously use Corsair fans without the commander pro, and honestly you’re only getting half of usage out of them because settings are limited without the commander pro. It’s still possible to use fans without it but honestly being able to control everything from the iCue app is worth it, so if you can’t get it right away save up. I would say this product is essential to anyone using Corsair fans and iCue.
Disclaimer: I am just an average person that set this up.
|商品尺寸||13.31 x 6.91 x 1.55 cm; 108.86 克|
|Is Discontinued By Manufacturer||不是|