商品尺寸 | 27.18 x 10.67 x 5.59 cm; 652 克 |
---|---|
制造商 | ALZO Digital |
型号 | 8541617712 |
商品重量 | 652 g |
ALZO 短悬浮天花板视频投影仪支架带剪刀夹适用于 T 型杆连接带 25.4 厘米吊架
ALZO Short Suspended Drop Ceiling Video Projector Mount with Scissor Clamp for T-Bar Attachment with 10 inch Drop
页面含机器翻译,中文仅供参考,以原文为准
ALZO Short Suspended Drop Ceiling Video Projector Mount with Scissor Clamp for T-Bar Attachment with 10 inch Drop
广告
目前无货。
欢迎选购其他类似产品。
欢迎选购其他类似产品。
- 安装架适合所有具有 3 至 4 个安装螺丝孔的大型投影仪,但对于超过 20 磅的投影仪,我们建议使用连接到真正的天花板的支持线加强 T 形框架;适合 Epson、Optoma、Benq、Viewsonic 和大多数其他投影仪
- 易于安装在吊吊吊吊吊吊吊顶上,带 2.54 厘米宽的 T 形杆框,25 度间距;投影仪吊架长 25.4 厘米,辅助 20.32 厘米延长杆可添加到投影仪下部
- 包含一本美国注册安装手册,并附有插图和照片
- 包括剪刀夹和一个 20.32 cm 铝制悬挂杆和螺丝;*大蜘蛛安装支架范围为 30.48 cm,安装孔
- 不含投影仪;仅用于展示目的。
- Mount fits all larger projectors with 3 to 4 mounting screw holes weighing up to 20-pounds, but for projectors over 2 pounds, we recommend reinforcing the T-bar frame with a support wire that attaches to the true ceiling; fits Epson, Optoma, Benq, Viewsonic and most other projectors
- Easy to install on a suspended drop ceiling with a 1-inch wide T-Bar frame, with 25 degrees pitch; projector drop from the ceiling is 10 inches, and accessory 8-inch extension rods can be added to lower the projector
- Includes an AMERICAN WRITTEN installation manual with illustrations and photos
- Includes scissor clamp and one 8 inch aluminum suspension rod, and screws; maximum spider mount leg span is 12 inches, mount hole to mount hole
- Projector is not included; it is shown for demonstration purposes only
产品信息
技术细节
更多信息
ASIN | B074PCP7PG |
---|---|
用户评分 |
4.3 颗星,最多 5 颗星 |
Amazon.cn上架时间 | 2018年3月27日 |
我来补充
商品描述
这款易于安装的视频投影仪支架可支持多达 20 磅的投影仪,采用 T-Bar 框架悬挂的落天花板;它适合所有具有 3 至 4 个安装螺丝孔、重量达 20 磅的大型投影仪,但对于超过 2 磅的投影仪,我们建议用支撑线加固 T 型框架,固定在真正的天花板上。 简单组装包括所有金属零件以及一套组装螺丝和硬件。 两轴锁定倾斜可调节,约有 25 度间距,安装快捷且稳定。 带有 3 个或 4 个腿的弹跳蜘蛛支架固定在投影仪上。 蜘蛛安装的*大腿跨距为 30.48 厘米(安装孔以安装孔);角度的腿会略微减少*大腿部范围。 此安装架附带典型的安装螺丝,但有些投影仪可能需要使用投影仪随附的安装螺丝。 适合 Epson、Optoma、Benq、Viewsonic 和大多数其他投影仪。 投影仪落在天花板上,只有 25.4 厘米。 包括美国书写安装手册。 附件8英寸(约20.3厘米)延长杆可添加到投影仪下部。 不含视频投影仪,旨在展示目的。
无买家评论
5 星 (0%) |
|
0% |
4 星 (0%) |
|
0% |
3 星 (0%) |
|
0% |
2 星 (0%) |
|
0% |
1 星 (0%) |
|
0% |
评分是如何计算的?
在计算总星级评分以及按星级确定的百分比时,我们不使用简单的平均值。相反,我们的系统会考虑评论的最新程度以及评论者是否在亚马逊上购买了该商品。系统还会分析评论,验证评论的可信度。
此商品在美国亚马逊上最有用的商品评论
美国亚马逊:
3.7 颗星,最多 5 颗星
31 条评论

Amazon Customer
4.0 颗星,最多 5 颗星
Good for the money.
2021年12月11日 -
已在美国亚马逊上发表已确认购买
Product is as described best as can be for the price , it is a little wobbly. It hasn't fallen or come loose so as I said for an inexpensive way to hang a projector on a drop ceiling it works . They might want to consider designing it so the wires can come down thru the post and the ability to lengthen or shorten the drop would be nice.
1 个人发现此评论有用

Alex
4.0 颗星,最多 5 颗星
Wish ordered it sooner
2021年10月11日 -
已在美国亚马逊上发表已确认购买
It’s very easy to install. Earlier I was using a tripod. I accidentally stumbled over it and my projector fell down. Wish I ordered this earlier. It so much clean. The only issue is the height. I was I could adjust it

Anthony
3.0 颗星,最多 5 颗星
Weak but it worked
2022年5月16日 -
已在美国亚马逊上发表已确认购买
Worked great for our old projector that was naturally balanced. Our new projector is very front heavy so I had to use aircraft wire to balance the load.

Nathan D. Croy
5.0 颗星,最多 5 颗星
It works, but be careful re: Optoma
2021年3月24日 -
已在美国亚马逊上发表已确认购买
Any reasonable weight projector with four mounting holes will be pretty good for this! Just make sure you're close to those hanging wires so it's solid. This does advertise that it comes with additional wire, but mine didn't.
It was my fault, but Optoma projectors usually have three mounting holes and I had to 3d print a modification to make this work.
It was my fault, but Optoma projectors usually have three mounting holes and I had to 3d print a modification to make this work.

Dellplanner
4.0 颗星,最多 5 颗星
Quick install, does the job.
2020年3月12日 -
已在美国亚马逊上发表已确认购买
Installs quickly, and is plenty sturdy if done correctly. Follow the instructions, remember It is critical that you position the center of the bracket with the center mass of the projector otherwise the down tube will be crooked and it will twist the ceiling rail. I suspect the reviews that state that this unit isn’t sturdy made this error.